The Resun Air Pump LP60 delivers with low noise a maximum air output of 4200L/hr (70 litres per minute), which is suitable for the vast majority of fish and koi ponds. It must be housed to be protected from dust ingestion. Dust will prematurely wear the rubber valves & diaphragms.

Installation hints:

• Do not install any brand of air pump of this size in the lounge room unless you like a continuous low noise hum whilst watching TV. Place the pump in a non-habitable room, or outside, and then plumb air line tubing to the tank diffusers.
• To increase the life of the rubber diaphragms, the unit must have back pressure. See details below.

Also used for: Air lift water pumping & aeration, Biocycle, envirocycle & ecocycle ddeep water aerobic septic tank aeration, Natural swimming pond or pool aeration, Aquaculture pond aeration, Commercial and industrial water aeration, Bubble baths

FEATURES

• Electromagmetic linear diaphragm technology
• Low noise. Decibel levels measured in a quiet room using A-frequency weighting with medium back pressure loading on the pump:
  41dB(A)+/- at 3m from air pump, 53dB(A)+/- at 500mm from air pump. A quite room ambient noise level is 30dB(A)+/-
• Cast aluminium body
• Voltage/Wattage: 240V / 60W
• Automatic thermal cut-out overload protection
• Cable length: 1.5m
• Max pressure: 0.037MPa
• Max air output: 4200L/hr (70 Litres/minute)
• Air pump outlet diameter: 20mm
• Must be set-up above the water level
• Important: Rated IPX4 (meaning – Should be placed in a low dust environment but will tolerate rain and light sprinkling)
• Maximum water depth for placed airstones or air diffuser: 3.5m
• Supplied with a plastic 14 outlet manifold to suit 4mm silicon air line
• Air Pump dimensions: 245mm(L) x 205mm(W) x 210mm(H)
• Weight: Air Pump, 5.45kg. Cartoned pump: 6.3kg

PLEASE NOTE:
To avoid premature or unexpected failure of the rubber diaphragms and valves:

• As preventive maintenance, the industry standard would require that all linear electromagnetic air pumps running 24/7 should be dismantled, air jet cleaned & have the diaphragms & valves replaced every 18 months or 12,000 hours
• The pump must only be used in a dust free environment.
• The pump must only be run with a back pressure load. Do not use for long periods with unrestricted air flow. This will stretch the diaphragms to cause premature tearing or distortion. Back pressure is created by having the air diffusers or air stones deep in the water or if not possible, a flow control tap fitted into the air line.